Comments on: How to get sticky gunk off wood floor after tile (vinyl or linoleum) removal? http://www.thebestprofessionalpainting.com/flooring-wood-and-tile/how-to-get-sticky-gunk-off-wood-floor-after-tile-vinyl-or-linoleum-removal#utm_source=feed&utm_medium=feed&utm_campaign=feed Houston, Texas Sat, 25 Jun 2011 22:44:59 +0000 hourly 1 http://wordpress.org/?v=3.2.1 By: Wullie http://www.thebestprofessionalpainting.com/flooring-wood-and-tile/how-to-get-sticky-gunk-off-wood-floor-after-tile-vinyl-or-linoleum-removal#comment-1078 Wullie Wed, 24 Feb 2010 19:50:59 +0000 http://www.thebestprofessionalpainting.com/flooring-wood-and-tile/how-to-get-sticky-gunk-off-wood-floor-after-tile-vinyl-or-linoleum-removal#comment-1078 You can just lay your new tiles over the sticky glue residue. Just scrape off any thick patches so the new floor is level.<br><b>References : </b><br> You can just lay your new tiles over the sticky glue residue. Just scrape off any thick patches so the new floor is level.
References :

]]> By: www.carpentrypages.com http://www.thebestprofessionalpainting.com/flooring-wood-and-tile/how-to-get-sticky-gunk-off-wood-floor-after-tile-vinyl-or-linoleum-removal#comment-1077 www.carpentrypages.com Wed, 24 Feb 2010 19:22:59 +0000 http://www.thebestprofessionalpainting.com/flooring-wood-and-tile/how-to-get-sticky-gunk-off-wood-floor-after-tile-vinyl-or-linoleum-removal#comment-1077 You can buy a thin sheet of plywood nail it to the floor this is called a subfloor then put the tiles on it will be much easier then trying to get the glue off the floor Good Luck hope this helped you <br><b>References : </b><br>http://www.carpentrypages.com You can buy a thin sheet of plywood nail it to the floor this is called a subfloor then put the tiles on it will be much easier then trying to get the glue off the floor Good Luck hope this helped you
References :
http://www.carpentrypages.com

]]> By: a3eracer http://www.thebestprofessionalpainting.com/flooring-wood-and-tile/how-to-get-sticky-gunk-off-wood-floor-after-tile-vinyl-or-linoleum-removal#comment-1076 a3eracer Wed, 24 Feb 2010 18:49:59 +0000 http://www.thebestprofessionalpainting.com/flooring-wood-and-tile/how-to-get-sticky-gunk-off-wood-floor-after-tile-vinyl-or-linoleum-removal#comment-1076 best way i have found is to use a chemical adhesive remover, pour it on the floor, scrub it with a stiff bristle brush or broom, mop up excess, and allow to dry before installing new tiles. depending on your existing sub floor ( is it rough, wavy, or damaged) you may need to install a 1/4 inch plywood laminate over the floor, fill all seams and nails then prime the floor with a special primer made for peel and stick tiles. any home improvement store can set you up.<br><b>References : </b><br> best way i have found is to use a chemical adhesive remover, pour it on the floor, scrub it with a stiff bristle brush or broom, mop up excess, and allow to dry before installing new tiles. depending on your existing sub floor ( is it rough, wavy, or damaged) you may need to install a 1/4 inch plywood laminate over the floor, fill all seams and nails then prime the floor with a special primer made for peel and stick tiles. any home improvement store can set you up.
References :

]]> By: chicagirl51 http://www.thebestprofessionalpainting.com/flooring-wood-and-tile/how-to-get-sticky-gunk-off-wood-floor-after-tile-vinyl-or-linoleum-removal#comment-1075 chicagirl51 Wed, 24 Feb 2010 18:10:59 +0000 http://www.thebestprofessionalpainting.com/flooring-wood-and-tile/how-to-get-sticky-gunk-off-wood-floor-after-tile-vinyl-or-linoleum-removal#comment-1075 You can try some goo-gone and a putty knife. If it's not really "lumpy" (fairly smooth) then install the tiles over it. Is the wood plywood OSB or wood plank? If it is osb or wood plank, redeck it with luann. If it is plywood try a product called AFTA:http://www.the5and10.com/index.cfm/CategoryID/30 This stuff will remove almost any glue and it has a high alcohol content so it evaporates fast and will leave little residue. After you are done. you will need to let it dry for a few days, 48 hours. Run a feather finish:http://www.ardex.com/prod-feather_finish-inst.htm patch on all the floor joints with a 6" drywall knife, sand it down after it drys.(80 grit paper) roll on a latex liquid primer:http://www.floorprep.com/additives.html#latexliquid to remove all the dust particles. KEEP THE FLOOR CLEAN! no dust....you can buy this by the gallon at most boxstores. (Dust is the downfall of peel and stick tile.) Let it dry good. <br><b>References : </b><br> You can try some goo-gone and a putty knife. If it’s not really "lumpy" (fairly smooth) then install the tiles over it. Is the wood plywood OSB or wood plank?
If it is osb or wood plank, redeck it with luann.
If it is plywood try a product called AFTA:http://www.the5and10.com/index.cfm/CategoryID/30
This stuff will remove almost any glue and it has a high alcohol content so it evaporates fast and will leave little residue. After you are done. you will need to let it dry for a few days, 48 hours. Run a feather finish:http://www.ardex.com/prod-feather_finish-inst.htm
patch on all the floor joints with a 6" drywall knife, sand it down after it drys.(80 grit paper)
roll on a latex liquid primer:http://www.floorprep.com/additives.html#latexliquid
to remove all the dust particles. KEEP THE FLOOR CLEAN! no dust….you can buy this by the gallon at most boxstores.
(Dust is the downfall of peel and stick tile.)
Let it dry good.

References :

]]> By: Kristin R http://www.thebestprofessionalpainting.com/flooring-wood-and-tile/how-to-get-sticky-gunk-off-wood-floor-after-tile-vinyl-or-linoleum-removal#comment-1074 Kristin R Wed, 24 Feb 2010 17:21:59 +0000 http://www.thebestprofessionalpainting.com/flooring-wood-and-tile/how-to-get-sticky-gunk-off-wood-floor-after-tile-vinyl-or-linoleum-removal#comment-1074 Unless its really ridgy, just apply more glue and stick em down. If its ridgy get a stripper (at the hardware store, not the bar) and use that to remove the gunk.<br><b>References : </b><br> Unless its really ridgy, just apply more glue and stick em down. If its ridgy get a stripper (at the hardware store, not the bar) and use that to remove the gunk.
References :

]]> By: Cara N http://www.thebestprofessionalpainting.com/flooring-wood-and-tile/how-to-get-sticky-gunk-off-wood-floor-after-tile-vinyl-or-linoleum-removal#comment-1073 Cara N Wed, 24 Feb 2010 16:47:59 +0000 http://www.thebestprofessionalpainting.com/flooring-wood-and-tile/how-to-get-sticky-gunk-off-wood-floor-after-tile-vinyl-or-linoleum-removal#comment-1073 you need to get a sander and sand down your whole floor we just had to do the same thing a few months ago<br><b>References : </b><br> you need to get a sander and sand down your whole floor we just had to do the same thing a few months ago
References :

]]>